Items needed to remove Rejuvenate Restorer:

Bottle of AMMONIA FREE glass cleaner like Windex Crystal Rain

Nylon sponge, mesh scrubber or non-abrasive/light weight scour pad

Clean microfiber mitt (or towel)

Directions for removal:

NOTE: If you have the type of cabinet doors that are removable you may choose to remove them and lay them flat on dropcloth to facilitate the process.

Spray an even coat of ammonia free glass cleaner onto a small area (aproximately 1/4 of the cabinet door) where Rejuvenate is to be removed.

If removing Rejuvenate from doors that are still attached and vertical , start from the top and work your way down.

Allow the cleaner to settle and react with Rejuvenate for no more than 5 minutes. DO NOT apply so much of the ammonia free glass cleaner that it forms puddles if you are working with wood surfaces. Excessive liquids of any kind can warp and/or damage wood surface.

After a few minutes, you will begin to see a slightly milky color develop. This is expected and means the Crystal Rain is reacting with the Rejuvenate. If you rub the surface with your finger you should feel the Rejuvenate pilling up and lifting from the surface. You can slowly agitate the surface with your fingers or the scrubber to try and speed up the process. You can add more Crystal Rain to the surface sparingly while you are agitating the surface.

Dampen the scrubber and scrub the previously prepared area. You can apply ample pressure as though you were cleaning dried liquid, however do not apply so much pressure that you scratch the surface. The amount of cleaner and pressure needed can vary depending on amount of coats and/or how long the surface has been Rejuvenated.

Once the entire area has been scrubbed, clean the area using a clean, dry Microfiber Mitt or towel to remove any residue from the Rejuvenate and/or Remover.

Repeat steps until your entire surface has been completed.

Once finished, clean the surface using the Rejuvenate Multi Surface Cleaner according to the directions on the bottle.

Allow the surface to dry completely before re-applying Rejuvenate Restorer.

Do's & Don'ts

DO work one small area at a time

DO allow ammonia free glass cleaner to react with the Rejuvenate before scrubbing

DO repeat steps as needed

DO NOT apply excessive amounts of ammonia free cleaner to wood surfaces
DO NOT apply excessive force when scrubbing wood surfaces
DO NOT use a glass cleaner with ammonia in it

How to remove Rejuvenate Restorer Floors | Cabinets

Items needed to remove Rejuvenate Restorer:

Directions for removal:

Do's & Don'ts

Hardwood

Laminates

Paneling

Formica®

Finished Wood