Depending upon age or finish on your cabinets you may need more than one coat of Rejuvenate Cabinet Restorer to get a deep, rich shine. You may apply additional coats to increase the level of shine and protection without any build-up. We recommend applying at least two coats for a wonderful satin type finish. If you prefer even more shine, apply a 3rd or even a 4th coat, just be sure to allow the Rejuvenate to dry completely between coats. (20 Minutes should be long enough in most cases).

If any streaking occurs, apply an additional coat perpendicular to the streaking lines. Allow 20 minutes to dry, then buff with a microfiber applicator mitt or cloth. Light streaking can often be fixed by applying an additional coat of Rejuvenate. If after applying an additional coat the streaking is still visible, then removal is necessary. Be sure that your microfiber mitt is clean and doesn't have pieces of material stuck in the fibers that could cause streaking.

To ensure superior results when applying additional coats of Rejuvenate Restorer, follow these simple application guidelines

Use a new / clean Microfiber Applicator Mitt

Pour liberally onto the Microfiber Applicator Mitt and wipe on all wood
surfaces with overlapping strokes going with the grain.

On vertical surfaces, start at top and work towards bottom

Apply slightly overlapping strokes in the same direction

For wood, apply strokes that go with the grain

For Formica and other laminates, use a circular overlapping motion

Do not re-work the same surface area multiple times

Apply to one area, then move onto the next area

Allow 20 - 30 minutes to dry

We recommend applying at least two coats for a wonderful satin type finish

If you prefer even more shine, apply a 3rd or even a 4th coat

If streaking occurs, apply an additional coat perpendicular to streak

Do's & Don'ts

DO clean & prep surface thoroughly before restoring.
DO apply one coat at a time.
DO apply from top to bottom on vertical surfaces.
DO apply in strokes that go with the grain.
DO wash the mitt applicator directly after use.

DO NOT shake product before application.
DO NOT rework the same surface area multiple times while wet.
DO NOT clean with any other brand products than Rejuvenate brand.

DO NOT use steam or any other heated appliance on Rejuvenated surfaces.

DO NOT apply a second coat of Rejuvenate until first coat dries COMPLETELY.

IMPORTANT: Be certain to thoroughly clean and prep before you apply Restorer. REMOVING ALL OIL, WAX AND RESIDUE before you apply Rejuvenate Restorer is the key to superior results. If your surfaces aren't clean and residue free, Rejuvenate Restorer cannot bond correctly.